High-pressure Hose suppliers Introduce products commonly used remedies


Upload Time:

2023-03-14

High-pressure Hose suppliers will introduce to you: high-pressure hose adhesive repair method When the rubber hose with the pressure of the hydraulic system is between 25-8.0MPa is broken, the sticky repair method can be adopted: wipe the area around the broken hose;

High-pressure Hose suppliers Introduce products commonly used remedies

High-pressure Hose suppliers will introduce to you: high-pressure hose adhesive repair method
When the rubber hose with the pressure of the hydraulic system is between 25-8.0MPa is broken, the sticky repair method can be adopted: wipe the area around the broken hose; apply "anaerobic" glue, "ring" to the broken hose One of "oxygen resin" glue, "801" glue or "502" glue (the length of the glue is about 2-3 times the length of the ruptured part); use tape or canvas strips to wrap the glued place in a laminated manner 4- 5 layers (each layer should be coated with glue); tie the two ends of the wrapping tape and scratch the canvas into a dead knot; wait for it to solidify for 15-20 minutes before use.

High-pressure Hose suppliers
High pressure hose modification method
High-pressure Hose suppliers tell you: due to the differences in the joints of rubber hoses in the hydraulic system, at the same time, high-pressure or ultra-high pressure ruptured hoses should not use the "glue method", "bundle method" or "bone method". Therefore, the reform method can be adopted: saw off the pipe joint of the ruptured hose; find an alternative hose with a pressure bearing capacity and length similar to the ruptured hose, and saw off its pipe joint; weld the angle of the pipe joint of the ruptured hose On the replacement hose; the welded hose is cleaned and ready to use.